Stewart-audio CVA100-2 User Manual download pdf (Page 9)

2.4.2 Unbalanced Input Connections

When using an unbalanced input source and connector, a jumper must

be added between the negative (-) terminals and the ground terminals.

Once this has been done, the unbalanced source can be connected to

the positive (+) and ground terminals. Please refer to the manual of

your input source in case it does not follow the standard pin-out. For

your convenience, pre-wired connectors are available for purchase, see

the next page for details.

NOTE: A jumper is required for connecting an unbalanced

input.

NOTE: The CVA 100-2 does not accept stereo inputs. Either

one side must be selected from the stereo source or an

overload-protected Y-cable must be used to sum them to

mono. It is highly recommended that you purchase the pre

-wired connectors mentioned on the next page. Damage to

source equipment can result from the use of a standard Y-

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 27 28

No comments

Stewart-audio CVA100-2 User Manual Page 9